A Trans Camshaft Plays an Important Role in Changing GearsUncategorized
Trans camshafts have no visible markings when you look at the engine bay. The only real way to be able to identify them is to learn about the different parts of the engine. A trans camshaft is a part of the transmission that controls the speed of the gears.
The transmission uses one ring gear
That connects to the other gears on the drive shaft. This ring gear is locked in place by a clutch, which is where the term “clutch” comes from. A trans camshaft takes care of shifting the gears on the first ring gear.
The next step in changing gears is the use of a tool called a nut and bolt, which transfers the motion from the driveshaft to the first ring gears. This is known as camshaft locking.
By doing this, the first gears can be shifted up to a higher speed while the second gears can be shifted down to a slower speed. This can be done by simply making one pass over the gears and having it spin for a while.
The next gears to be changed are the last two gears on the first gear set. Here, the difference between the speed of the two gears would determine the ability of the gears to make the transmission turn. If the two gears do not have the same speed, then the first gear will be used to make the other gears go faster or slower.
Here’s a diagram of how a trans camshaft operates
The first gear that has been shifted to the top position will remain there until the gears are all aligned in the correct pattern.
The next step would be to remove the plug and the seat bolts. Next, you would tighten them up. This will give the gears a little more resistance so they will turn faster. Now, you will tighten the rear nuts up. Use the same procedure of turning the rear nuts until they lock in place.
The last step is to take the plug off the top gears and turn the seat bolts in. This will take care of the misalignment problem with the two gears.
This will allow the last two gears to turn at the same speed
This is where the trans camshaft plays its part in the gears being shifted up or down.
Now, you will need to take the shift lever off and use a block of wood that will fit the lever. Place the lever on the block and turn it so the gears are lined up properly.
Then, apply lubricant to the motor to make the new trans camshaft work correctly. The total time that it takes is not too long, but it is enough to make you feel like you just stepped out of your old car into a brand new car.